Enantiomeric analysis of drugs in water samples by using liquid–liquid microextraction and nano-liquid chromatography

The nano-LC technique is increasingly used for both fast studies on enantiomeric analysis and test beds of novel stationary phases due to the small volumes involved and the short conditioning and analysis times. In this study, the enantioseparation of 10 drugs from different families was carried out by nano-LC, utilizing silica with immobilized amylose tris(3-chloro-5-methylphenylcarbamate) column. The effect on chiral separation caused by the addition of different salts to the mobile phase was evaluated. To simultaneously separate as many enantiomers as possible, the effect of buffer concentration in the mobile phase was studied, and, to increase the sensitivity, a liquid–liquid microextraction based on the use of isoamyl acetate as sustainable extraction solvent was applied to pre-concentrate four chiral drugs from tap and environmental waters, achieving satisfactory recoveries (>70%).     

Effect of Butyric Acid on p53 Expression and Apoptosis in Colon Epithelial Cells in Mice after Treated with 9,10-dimethyl-1,2-benz(a)anthracene

As the most common cancer, colorectal cancer is the fourth leading cause of death among this malignancy disease. Surgery procedure with chemotherapy and radiotherapy for colorectal cancer treatment may cause unpleasant side effects. Therefore, prevention and early detection of the disease is important. Butyrate, a short chain fatty acid, has a protective effect against colon cancer by inhibiting cell proliferation and inducing apoptosis. We conduct a research to investigate the effect of butyrate as a possible agent to decreased mutant p53 gene expression.     

丁酸钠预培养对水稻花药绿苗形成的影响

对水稻花药进行了丁酸钠预培养的试验,结果表明:2mM丁酸钠24小时的预处理,可以促进小孢子的均等分裂,增加多核花粉的比例,并影响愈伤组织诱导率和愈伤组织的分化绿苗潜力,对愈伤组织分化绿苗的促进作用尤其显著。丁酸钠对愈伤组织诱导的作用,与介质的pH的值有关,pH7.0的培养基的诱导率低于pH5.8,但对分化有利。 文章讨论了丁酸钠促进愈防组织分化的可能原因,以及丁酸钠影响愈伤组织诱导和促进分化之间关系。     

铸膜液溶剂体系的物理参数与BCA不对称膜的透气性

铸膜液的溶剂体系（溶剂和非溶剂）对不对称膜形态的形成有重要作用。为了探索溶剂和透气性间的关系，本文考虑到了制备ＢＣＡ梯度密度不对称膜的各种溶剂的一系列物理参数，得到了一些定性结果，并指出了更全面、明确、解释两者关系的研究方向。     

纳米复合锆基固体超强酸的制备及其催化酯化反应

采用改性技术和浸渍—沉淀法制备出纳米固体超强酸催化剂S2O82-/ZrO2-Al2O3。通过正交试验获得催化剂制备的最佳条件,即ω(Al2O3)为2.0%,-15℃陈化24h,浸渍液(NH4)2S2O8浓度为0.8mol/L,焙烧温度为650℃,焙烧时间为3h。用XRD、TEM、BET、TG-DTG和化学分析等手段分析了S2O82-/ZrO2-Al2O3的晶化过程、比表面积、含硫量和热稳定性,分析结果表明这四个方面对催化剂的酸性有较大影响。500~650℃焙烧温度下制备的催化剂属纳米材料(<41nm),有较大比表面积和较好的热稳定性。以优化的催化剂S2O82-/ZrO2-Al2O3用于催化合成丁酸异丁酯的最佳条件为:n(异丁醇):n(丁酸)=1.8:1.0,催化剂用量为1.0g(以0.3mol丁酸为准),脱水剂环己烷用量为10mL,反应时间为3.0h,催化剂重复使用8次后酯化率仍在90%以上,该催化剂具有催化活性高、不污染环境、可重复使用等特点。     

Cellulose-based fibers from liquid–crystalline solutions. II. Processing and morphology of acetate/butyrate esters

Fibers were spun from isotropic and anisotropic dimethylacetamide solutions of cellulose esters. Take-up speeds of the dry jet/wet spinning process varied. Water served as the coagulant. The mechanical properties of the fibers increased as spinning progressed from the isotropic to the anisotropic state of the solution. A trade-off in solubility and fiber properties was noted as the butyryl acetyl ratio decreased. Whereas high butyryl content enhances both overall solubility and the formation of liquid–crystalline solutions at lower concentration, it results in lower fiber modulus and strength. Morphology of the fibers depended on the coagulation rate which was influenced by the concentration of the sppinning solution. The level of orientation and crystallinity of the fibers increased somewhat when they were spun from liquid-crystalline solutions. © 1993 John Wiley & Sons, Inc.     

Characterization of cellulose derivatives — Relevance to sensor development

With the aim of developing a urea biosensor, several cellulose derivatives were used to coat an all-solid-state potentiometric electrode for ammonium ion determination. In this work the physical and chemical characterization of the cellulose derivatives, as well as the changes that the activation and immobilization procedures induced in the polymers, were studied.     

硫酸氢钠催化合成己酸异戊酯的研究

己酸异戊酯是应用最广泛的食用香料之一。通常它是在硫酸催化下由己酸和异戊醇酯化反应而得[1] ,硫酸虽然活性高 ,价廉 ,但选择性差 ,产品质量不好 ,设备腐蚀严重 ,同时产生大量废液 ,污染环境。已发现对甲苯磺酸、磺酸树脂、固体超酸、杂多酸、氯化铁以及过渡金属硫酸盐等均可作为酯化反应的优良催化剂[2～ 7] 。本文探讨了硫酸氢钠催化羧酸的酯化反应 ,结果发现它具有良好的催化性能 ,且后处理方便 ,无污染。1　实验部分在装有分水器、温度计和回流冷凝器的四颈烧瓶中 ,加入一定量分析纯的己酸、异戊醇、甲苯和催化剂硫酸氢钠 (ＮａＨＳＯ…     

Green synthesis of banana flavor using different catalysts: a comparative study of different methods

ABSTRACT

Esterification of isoamyl alcohol with acetic acid was studied using different ion-exchange resins, namely Amberlyst 15 dry, Amberlyst 16 wet, Amberlite 120-IR. Esterification was carried out using different esterification methods that are quite new (ohmic, ultrasonic probe, and ultrasonic bath) and the results were compared with microwave-assisted esterification (MAE). The highest isoamyl acetate yield (99%) was obtained by MAE, using a mixture of acetic acid and isoamyl alcohol (mole ratio of 1:2) after 2?h of reaction time. In this process, 2% Amberlyst 15 dry was used. MAE had the least specific energy consumption (0.42?kWh/g isoamyl acetate) and specific CO₂ emission (34?g/g isoamyl acetate). According to the images obtained by scanning electron microscopy, lower amounts of Amberlyst 15 dry beads were destroyed by MAE method compared to other esterification methods. In conclusion, MAE proved to be an economic and environmentally-friendly method for esterification of different flavoring compounds.     

铸膜溶剂对CAB膜形态和性能的影响

以ＣＡＢ高分子为膜材料，研究了铸膜液的溶剂体生添加剂对膜形态及选择性渗透Ｎ２、Ｏ２、ＣＨ４、ＣＯ２等气体的影响。溶剂体系以丙酮为基本组分，混合甲酰胺或乙酸，可得到具有好的气体渗透性或气体选择性的非对称膜，通过溶剂的红外光谱羰基吸收峰的偏移，认为溶剂体系有可能存在Ｌｅｗｉｓ酸；碱络合物。